Enterasys csx400 Installationsanweisungen

Chapter 4: Installation

4-4

CyberSWITCH CSX400 and CSX400-DC Installation Guide

This section describes how to remove the CSX400 chassis cover. The cover must be removed to 
install a WAN Port Interface Module.

To remove the chassis cover, proceed as follows: 

Disconnect the CSX400 from the network as follows:

Unplug the power cord from the rear of the CSX400 chassis.

Disconnect all network cables attached to the CSX400. 

Use a Phillips screwdriver to remove the seven screws that attach the chassis cover to the unit. 
Place the screws aside. (See 

).

While facing the back of the unit, remove the chassis cover by pulling the cover toward you and 
then up.

DO NOT REMOVE THE COVER FROM THE CSX400 WHILE POWER IS APPLIED 
TO THE UNIT.

DO NOT POWER UP THE DEVICE AGAIN UNTIL THE COVER AND SCREWS ARE 
IN PLACE.

DECKEL VON DAS CSX400 NICHT ABZIEHEN UNTER SPANNUNG.

CSX400 NICHEINSCHALTEN SO LANG DER DECKEL UND SCHRAUBEN NICHT 
EINGEBAUT SIND.

NO DEBE DE REMOVER LA TAPA DURENTE QUE ESTE CONELTADO A LA 
CORRIENTE.

NO ENCHUFE A LA CORRIENTE HASTA QUE LA TAPA Y LOS TORNILLOS ESTEN 
EN SU LUGAR.

Before performing 

, mark any cables connected to the CSX400 according to their 

associated port numbers. This is recommended for ease of reinstallation.