Enterasys csx150 Anleitung Für Quick Setup
QUICK START
36 CyberSWITCH
5.
Return to the Options menu, select IP Routing, then select Static Route. You will have to
configure a static route to the 199.2.2.0 LAN. When you configure a static route to a site that
uses a unnumbered interface you must enter the device name of the next hop device, Central in
this case.
configure a static route to the 199.2.2.0 LAN. When you configure a static route to a site that
uses a unnumbered interface you must enter the device name of the next hop device, Central in
this case.
IPX R
OUTER
TO
IPX R
OUTER
C
ONFIGURATION
Note:
This configuration illustrates IPXWAN routing only. If you are interested in configuring a
remote LAN interface (to connect a CyberSWITCH to remote bridge devices), refer to the
Example Networks Guide.
remote LAN interface (to connect a CyberSWITCH to remote bridge devices), refer to the
Example Networks Guide.
C
ONFIGURATION
FOR
S
ITE
"C
ENTRAL
"
The configuration on Central to allow IPX Routing to Remote using PPP is as follows:
1.
steps.
2.
Under Options, select IPX Routing, then:
a.
a.
Enable IPX Routing.
b.
Under IPX Internal Network Number enter the following value: 123456.
c.
Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(11111111).
(11111111).
3.
Under Security, select System Options and Information, then under System Information:
a.
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
configured on Remote.
b.
Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
configured on Remote.
4.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
Under ISDN Information select ISDN Line Protocol, then select PPP.
b.
Optional: If you wish to dial out to Remote, under ISDN Information you must enter a dial
out number (13135552222) and a base data rate (64Kb).
out number (13135552222) and a base data rate (64Kb).
ISDN
Network #11111111
Network # 33333333
FILESER2
Node # 0409A0222222
IN # 978901*
Node # 0409A0222222
IN # 978901*
FILESER1
Node # 0409A0111111
IN # 432109*
CSX1200
Phone # 13135551111
IN # 123456*
CSX150
Phone # 13135552222
IN # 456789*
Phone # 13135552222
IN # 456789*
* IN # = Internal Network Number
POWER
SERVICE
TX
RX
10BASE - T
LAN B-CHANNELS E1 ONLY
B2 B4
B6 B8
B26 B28
B22 B24
B18 B20
B14 B16
B10 B12
B30 L1
B1 B3
B5 B7
B25 B27
B21 B23
B17 B19
B13 B15
B9 B11
B29 B31
E1
D
T1
D
"Central"
"Remote"