Enterasys csx150 Anleitung Für Quick Setup

Small Office Remote Access Switch 37

ONNECTIVITY

Connecting One Cabletron Product to another via PPP

Under Authentication you must:
•

Change CHAP Secret so that it matches Remote’s System secret (Remote_S).

•

Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).

d. Under IPX Information:

•

enable IPX

•

enable Make Calls for IPX data

•

enable IPXWAN protocol

•

select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol
option

Note:

By using triggered RIP/SAP, you do not need to configure static routes or services.

ONFIGURATION

FOR

ITE

EMOTE

The configuration on Remote to allow IPX Routing to Central using PPP is as follows:

Perform

initial configuration

steps.

Under Options, select IPX Routing, then:
a.

Enable IPX Routing.

Under IPX Internal Network Number enter the following value: 456789.

Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(33333333).

Under Security, select System Options and Information, then under System Information:
a.

Set your System Name (Remote). This matches up with Remote device information
configured on Central.

Set your System Secret (Remote_S). This matches up with Remote device information
configured on Central.

Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a.

Under ISDN Information select ISDN Line Protocol then select PPP.

Under ISDN Information you must enter a dial out number (13135551111) and a base data
rate (64Kb) to dial out to Central.

Under Authentication you must:
•

Change CHAP Secret so that it matches Central’s System secret (Central_S).

•