Enterasys csx150 Anleitung Für Quick Setup
Small Office Remote Access Switch 39
C
ONNECTIVITY
Connecting One Cabletron Product to another via PPP
c.
Under AppleTalk Port Information, configure a WAN UnNumbered port:
•
•
Select the WAN UnNumbered port type.
d. Under AppleTalk Static Routes, configure a static route to Remote:
•
Enter Extended for Remote’s network type (the default).
•
Enter 45-50 as the destination network range (Remote’s network range).
•
Enter 0.0 as the next hop (it’s over an unnumbered link).
•
Enter Remote as the next hop’s device name.
•
Enter 2 as the number of hops for this route.
•
Enter Remote.Engineering as Remote’s default zone name.
•
Enter Remote.Marketing as Remote’s second zone name.
4.
Under Security, select System Options and Information, then under System Information:
a.
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
configured on Remote.
b.
Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
configured on Remote.
C
ONFIGURATION
FOR
S
ITE
"R
EMOTE
"
The configuration on Remote to allow AppleTalk Routing to Central is as follows:
1.
steps.
2.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a.
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a.
Under ISDN Information select ISDN Line Protocol, then select PPP.
b.
Optional: If you wish to dial out to Central, under ISDN Information you must enter a dial
out number and a base data rate (64Kb).
out number and a base data rate (64Kb).
c.
Under Authentication you must:
•
•
Change CHAP Secret so that it matches Central’s System secret (Central_S).
•
Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
d. Under AppleTalk Information you must:
•
Enter 0.0 for the AppleTalk address.
•
Enable AppleTalk Routing.
•
Enable making calls for AppleTalk data.
3.
Under Options, select AppleTalk Routing, then:
a.
a.
Enable AppleTalk routing.
b.
Under AppleTalk Port Information, configure a LAN port:
•
•
Select the LAN port type.
•
Enter lanport1 for the port name.
•
Enter 1 for the LAN port number.
•
Select the Extended network type (the default).
•
Enter 45-50 for the network range.
•
Accept the default of none for the suggested AppleTalk address.
•
Enter Remote.Engineering as the port’s default zone name.
•
Enter Remote.Marketing as the second zone name.