Enterasys csx150 Betriebsanweisung
Small Office Remote Access Switch 375
P
ROBLEM
D
IAGNOSIS
IP Routing Over Interface Connections
encapsulations. Correct the IP Host or system configuration (through CFGEDIT) for
encapsulation type.
encapsulation type.
5.
Try to ping the Host from another device on the LAN. If this is also unsuccessful, this may
indicate a problem with the Host.
indicate a problem with the Host.
6.
Verify that the hardware address (MAC address) for the IP Host in the system’s ARP cache is
correct. If it is not correct, verify the configuration in the IP Host.
correct. If it is not correct, verify the configuration in the IP Host.
IP R
OUTING
O
VER
A
WAN I
NTERFACE
C
ONNECTION
Problem:
The remote IP Host connected to a WAN interface does not receive a ping response from the
CyberSWITCH WAN interface.
The remote IP Host connected to a WAN interface does not receive a ping response from the
CyberSWITCH WAN interface.
Action:
1.
1.
Verify that the WAN connection is up. Use the
mc
console command to display the Connection
Monitor display. Check for the connection. If the connection is up, continue with the next step.
If the connection is not up, refer to the section titled
.
2.
Verify that the WAN interface is properly initialized. Use the
ipnetif
command (Manage
Mode) to check for the proper WAN interface. If it exists, continue with the next step.
If the proper WAN interface does not exist, make corrections to the system configuration using
CFGEDIT.
CFGEDIT.
3.
Check that the IP address configured in the Device list for the IP Host device matches the
address configured on the IP Host device. Make corrections to the CyberSWITCH’s
configuration (using the
address configured on the IP Host device. Make corrections to the CyberSWITCH’s
configuration (using the
iproute change
Manage Mode command), or to the IP Host’s
configuration, as required.
Problem:
The remote IP Host connected to a WAN interface on the CyberSWITCH does not receive a ping
response from the LAN interface.
The remote IP Host connected to a WAN interface on the CyberSWITCH does not receive a ping
response from the LAN interface.
Action:
1.
1.
Verify that the remote IP Host can access the WAN interface of the CyberSWITCH. If the
remote IP Host accesses the WAN interface successfully, then continue with the next step.
remote IP Host accesses the WAN interface successfully, then continue with the next step.
If the remote IP Host is not able to access the WAN interface, then refer to the preceding
problem and associated actions.
problem and associated actions.
2.
Verify that the LAN interface is properly configured by using the
ipnetif
command (a
Manage Mode command). If the proper LAN interface exists, then continue with the next step.
If the proper LAN interface does not exist, use CFGEDIT to make corrections.
3.
Verify that the remote IP Host is initiating a call to the CyberSWITCH. Since the LAN interface
has an IP address assigned with a different network number than the one for the remote IP
has an IP address assigned with a different network number than the one for the remote IP