Enterasys D2G124-12P Installationsanweisungen
Mounting the Switch
2-12 Installation
a.
With the hook and loop sides attached together, peel back the adhesive covering on one
side of each hook & loop fastener and apply to opposite corners on the bottom of the
D2‐HIPWR‐POE.
side of each hook & loop fastener and apply to opposite corners on the bottom of the
D2‐HIPWR‐POE.
b. Once the hook & loop fasteners are adhered to the bottom of the D2‐HIPWR‐POE, remove
the adhesive covering on the other side of both hook & loop fasteners and adhere to the
table mounting tray.
table mounting tray.
c.
Firmly press the D2‐HIPWR‐POE against the table mount tray and hold together for a few
seconds.
seconds.
8.
Plug the DC power cord from the power supply into the switch DC power receptacle that is
appropriate for your type of power supply.
appropriate for your type of power supply.
•
For the D2‐PWR supply, plug into the PWR1‐A or PWR2‐A receptacle on the switch.
•
For the D2‐PWR‐POE supply, plug into the PWR1‐B or PWR2‐B receptacle on the switch.
•
For the D2‐HIPWR‐POE, see “
9.
Plug the AC cord into the power supply’s AC receptacle.
10. (Optional) Use the wire ties provided to secure the power cords inside the table mounting
tray.
11. Using appropriate screws and the four screw holes in the corner edges of the table mounting
tray, attach the assembled kit underneath your desired table location. Mount the assembled
unit in place by positioning the screw holes over your installed table screws and pulling
slightly forward on the unit.
unit in place by positioning the screw holes over your installed table screws and pulling
slightly forward on the unit.
12. Attach network cables. Refer to “
” on page 2‐28 for more
information.
13. Plug each AC power cord into a dedicated, grounded AC outlet. See “
” on page 2‐26 for information on redundancy and the initialization process.
Installing the Switch on a Wall
To install the switch in the wall mount kit and then install it on a wall, refer to
page 2‐13 and proceed as follows:
Note: Once assembled, the serial number on the bottom of your D2 switch will be visible through
the window on the bottom of the table mount kit.
the window on the bottom of the table mount kit.
Caution: The wall location and wall mounting screws/anchoring method that the installer selects for
mounting the D2 switch must be capable of supporting 55 lbs (25kg).
Advertencia: La ubicación de la pared y el método de anclaje o los tornillos de montaje de la pared
que el instalador seleccione para montar el interruptor D2 deberán ser capaces de soportar un peso
de 55 lbs (25 kg).
mounting the D2 switch must be capable of supporting 55 lbs (25kg).
Advertencia: La ubicación de la pared y el método de anclaje o los tornillos de montaje de la pared
que el instalador seleccione para montar el interruptor D2 deberán ser capaces de soportar un peso
de 55 lbs (25 kg).