Enterasys b2g124-24 Benutzerhandbuch
Connecting to Console Port for Local Management
SecureStack B2 Installation Guide 3-19
Figure 3-9 DB9 Male Console Port Pinout Assignments
Connecting to an IBM or Compatible Device
To connect an IBM PC or compatible device, running the VT terminal emulation, to an
Enterasys switch Console port (
Enterasys switch Console port (
), proceed as follows:
1.
Connect the DB9 female connector at one end of the cable (not supplied) to the
Console port on the Enterasys switch. (If there is a switch designated as the Manager,
connect to its Console port.)
Console port on the Enterasys switch. (If there is a switch designated as the Manager,
connect to its Console port.)
2.
Plug the DB9 female connector at the other end of cable into the communications port
on the PC.
on the PC.
3.
Turn on the PC and configure your VT emulation package with the following
parameters:
parameters:
When these parameters are set, the Startup screen will display. Proceed to “
1 Pin 2, Received Data (input)
2 Pin 3, Transmitted Data (output)
3 Pin 5, Signal Ground
2 Pin 3, Transmitted Data (output)
3 Pin 5, Signal Ground
All other pins not connected.
Â
À
Á
5
1
9
6
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit