ZyXEL nbg-4615 Betriebsanweisung

Chapter 12 WISP Mode

NBG4615 User’s Guide

Use this screen to scan for and connect to a wireless network automatically. Go to 
Configuration > Site Survey to open the following screen.

Figure 71   Configuration > Wireless LAN > Site Survey (WISP)

The following table describes the labels in this screen. 

Pre-Shared Key  WPA-PSK/WPA2-PSK uses a simple common password for 

authentication.

Type the pre-shared key employed by the access point to which you 
want to connect. 

Apply

Click Apply to save your changes back to the NBG4615.

Cancel

Click Cancel to reload the previous configuration for this screen.

Table 39   WPA-PSK/WPA2-PSK (WISP) (continued)

Table 40   Configuration > Wireless LAN > Site Survey (WISP)

Station Site Survey
#

Select a wireless device and click Add Profile to open a configuration 
screen where you can add the selected wireless device to a profile and 
then enable it.

SSID

This displays the SSID of the wireless device.

 indicates the wireless device is added to an activated profile and the 
NBG4615 is connecting to it.

BSSID

This displays the MAC address of the wireless device.

Signal 
Strength

This displays the strength of the wireless signal. The signal strength 
mainly depends on the antenna output power and the distance between 
your NBG4615 and this device.

Channel

This displays the channel number used by this wireless device. 

station 
encryp

This displays the data encryption method used by this wireless device.

station auth

This displays the authentication method used by this wireless device.