ZyXEL GS-4024 Zusätzliches Handbuch
Protocol Based VLAN Support Note
8
Configuration via CLI on ZyXEL Management Switch
Connect your PC or Notebook to the Switch Console.
1. Open your Terminal program (e.g. Hyper Terminal in Windows System).
2. Make sure your port settings are:
bps:9600
Data bits:8
Parity: None
Stop bits:1
Flow control: None:
Another way is to telnet / SSH the IP of the Switch Management Interface.
For In-band interface, the default management IP is 192.168.1.1 (VLAN 1).
For Out-band interface, the default management IP is 192.168.0.1
3. When successfully connected, enter the correct administrator user name
and password.
4. Now you are in the privileged mode.
5. Then issue command “configure” to switch to the configuration mode.
Issue the following commands to use Protocol Based VLAN to sort out all the
PPPoE traffic on port 1 and mark it with VID 500 and assign it 802.1p priority of
1.
To enable Protocol Based VLAN on port 1:
Switch(config)# interface port-channel 1
Switch(config-interface)#protocol-based-vlan name PPPoE1 ethernet-type
0x8863 vlan 500 priority 1
Switch(config-interface)#protocol-based-vlan name PPPoE2 ethernet-type
0x8864 vlan 500 priority 1
Switch(config-interface)#exit
To save your configuration under privileged mode:
All contents copyright (c) 2006 ZyXEL Communications Corporation.