ZyXEL 793H Betriebsanweisung
Chapter 4 Point-to-(2)point Configuration
P-793H User’s Guide
64
To establish a point-to-point connection, one of the ZyXEL Devices becomes the server
(instead of the ISP). The server controls some of the attributes of the DSL connection, such as
the transfer rate and the DSL operational mode. Otherwise, there is no difference between the
server and the client. Either one can initiate the point-to-point connection.
You can only establish point-to-point connections between ZyXEL Devices that support this
kind of server/client mode.
(instead of the ISP). The server controls some of the attributes of the DSL connection, such as
the transfer rate and the DSL operational mode. Otherwise, there is no difference between the
server and the client. Either one can initiate the point-to-point connection.
You can only establish point-to-point connections between ZyXEL Devices that support this
kind of server/client mode.
4.2 Point-to-point Connection Procedure
Follow these directions to set up a point-to-point connection.
1
2
3
.
4.2.1 Set up the Server
1 Log in to the ZyXEL Device that will be the server. (See
2 Click Network > WAN > Internet Connection.
3 Configure the VPI, VCI, Multiplexing, and Encapsulation fields for the point-to-point
3 Configure the VPI, VCI, Multiplexing, and Encapsulation fields for the point-to-point
connection. In the Encapsulation field, select either RFC 1483 or ENET ENCAP.
4 Scroll down to the Service Type section. The following screen appears.
Figure 22 WAN > Internet Connection > Service Type
5 In the Service Mode field, indicate whether the phone line is a 2-wire connection or a 4-
wire connection.
6 In the Service Type field, select Server. The rest of the fields are enabled.
7 Configure the rest of the fields, if necessary. For example, you might want to set the
7 Configure the rest of the fields, if necessary. For example, you might want to set the
Transfer Max Rate to the maximum value.
8 Click Apply.
4.2.2 Set up the Client
1 Log in to the ZyXEL Device that will be the client. (See
2 Click Network > WAN > Internet Connection.