ZyXEL g-2000 plusv2 Betriebsanweisung
ZyXEL G-2000 Plus v2 User’s Guide
Chapter 30 SNMP Configuration
315
Figure 174 Menu 22 SNMP Configuration
The following table describes the SNMP configuration parameters.
30.4 SNMP Traps
The ZyXEL device will send traps to the SNMP manager when any one of the following
events occurs:
events occurs:
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Table 111 Menu 22 SNMP Configuration
FIELD
DESCRIPTION
SNMP:
Get Community
Type the Get Community, which is the password for the incoming Get- and
GetNext requests from the management station.
Set Community
Type the Set Community, which is the password for incoming Set requests from
the management station.
Trusted Host
If you enter a trusted host, your ZyXEL device will only respond to SNMP messages
from this address. A blank (default) field means your ZyXEL device will respond to
all SNMP messages it receives, regardless of source.
Trap:
Community
Type the trap community, which is the password sent with each trap to the SNMP
manager.
Destination
Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Table 112 SNMP Traps
TRAP #
TRAP NAME
DESCRIPTION
1
coldStart (defined in RFC-1215)
A trap is sent after booting (power on).
2
warmStart (defined in RFC-1215)
A trap is sent after booting (software reboot).
3
linkUp (defined in RFC-1215)
A trap is sent when the port is up.