ZyXEL g-2000 plusv2 Guía Del Usuario

ZyXEL G-2000 Plus v2 User’s Guide

Chapter 30 SNMP Configuration

315

The following table describes the SNMP configuration parameters.

The ZyXEL device will send traps to the SNMP manager when any one of the following 
events occurs:

Menu 22 - SNMP Configuration

SNMP:
  Get Community= public
  Set Community= public
  Trusted Host= 0.0.0.0
  Trap:
    Community= public
    Destination= 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

Table 111   Menu 22 SNMP Configuration

SNMP:

Get Community

Type the Get Community, which is the password for the incoming Get- and 

GetNext requests from the management station.

Set Community

Type the Set Community, which is the password for incoming Set requests from 

the management station. 

Trusted Host

If you enter a trusted host, your ZyXEL device will only respond to SNMP messages 

from this address. A blank (default) field means your ZyXEL device will respond to 

all SNMP messages it receives, regardless of source.

Trap:

Community

Type the trap community, which is the password sent with each trap to the SNMP 

manager. 

Destination

Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

Table 112   SNMP Traps

1

coldStart (defined in RFC-1215)

A trap is sent after booting (power on).

2

warmStart (defined in RFC-1215)

A trap is sent after booting (software reboot).

3

linkUp (defined in RFC-1215)

A trap is sent when the port is up.