Cleveland cr-28 Betriebsanweisung

Start the Cooking Program
Press the Menu Item key on the control panel that
corresponds to the type and amount of food you are
cooking.  This will begin the countdown from the total
cooking time.  Notice the red light for the active
cooking program will flash continuously. On fireplace
units, if you want the fireplace ON, push the fireplace
switch to Auto. If you want the interior light ON, push
the light switch to Auto.

During the Cooking Program
1.  When the cook program starts, the oven

automatically calculates and displays the total
cook time (of all stages).  It then counts down to
show the total time remaining in the cooking
program.

2.  You can open the door at any time during

cooking.  When the door is opened, the burner,
the convection fans, the rotor, the lights, timing,
and fireplace (if equipped) will stop automatically.
This allows you to check the product temperature
or to correct a problem.

3.  TO CANCEL a cooking program, push the menu

item key that is flashing and hold it for 5 seconds.
This will cancel the program.

At the End of the Cooking Program
The controller will count the cooking time down to
“zero”.  It will then sound the Audible Tone for 5

Co-Cook is a secondary cooking-time that can be
programmed for buttons 1 through 13 (see System
Level Programming).  Any or all of these keys can
be programmed to any desired time duration, for
example 45 minutes for one key and 1 hour and 10
minutes for another.

To use co-cook, once you have started your
primary cook cycle, you can press a second button
to start a second timing cycle for cooking a second
product that has been loaded into the oven.

Only the time can be programmed for co-cook.  All
other parameters – temperature, speed, fan, etc. –
are controlled according to the primary cook
program parameters.

The rotisserie oven’s Co-Cook feature allows you to
cook two different products in the oven at the same
time.

You can load both products at the same time, or load
the second item later.  The one restriction is that the
co-cook time for the second item must be shorter

seconds and show the message “DONE” on the
display.
If within 5 seconds, you don’t open the door to begin
unloading, the controller will automatically enter the
HOLD mode.
To silence the Audible Tone, you can open the
door, or you can press the Menu Item button that is
flashing.

Adding Additional Cook Time
1.  Add Cooking Time – You may check the internal

temperature of the product using a meat
thermometer.  If the product has not reached the
desired temperature, add 5 or 10 minutes more
cooking time by pressing key 14 or 15.

2.  After Added Cooking is Complete – The Audible

Tone will sound and the controller will
automatically start the HOLD Mode.

In Case of Power Failure
1.  If power is restored within 5 minutes, the

controller will continue the cooking cycle where it
left off.

2.  If power is off longer than 5 minutes, the

controller will return to Preheat/Ready Mode
when power is restored. Follow your established
restaurant procedures to either restart cooking or
discard product depending on the length of the
power outage.

than the total cook time remaining for the first item.

To use Co-Cook, press the first menu item key to
start the first time clock.  The display will show the
total time remaining for the first item.  Then,
whenever the second item has been loaded, press
the second menu item key that corresponds to the
amount of time you want.  The light of the co-cook
menu item will flash at a faster rate than the primary
item.

After pressing the second menu item key, the display
will show the total cook time for the second item, and
will begin counting down.  (The clock for the first item
continues counting down, but this occurs in the
background and is not visible in the display.)

To cancel co-cook, press the menu item button for 2
to 3 seconds, until the light turns off.

When the co-cook time reaches zero, the Audible
Tone sounds.  The clock resets itself and shows the
cook time remaining for the primary menu item.  The
first item will now complete its cooking cycle.  You
must unload the second item right away to keep it
from overcooking.