Fortinet fortigate-200a Installationsanweisungen

Use the web-based manager to complete the initial configuration of the FortiGate 
unit. You can continue to use the web-based manager for all FortiGate unit 
settings. 

For information about connecting to the web-based manager, see 

. The first time you connect to the FortiGate 

unit, it is configured to run in NAT/Route mode.

Go to System > Status.

Select Change beside the Operation Mode.

Select Transparent in the Operation Mode list.

Type the Management IP/Netmask address and the Default Gateway address you 
gathered in 

. 

Select Apply.

You do not have to reconnect to the web-based manager at this time. Once you 
select Apply, the changes are immediate, and you can go to the system 
dashboard to verify the FortiGate unit has changed to Transparent mode. 

Go to System > Network > Options.

Enter the IP address of the primary DNS server. 

Enter the IP address of the secondary DNS server.

Select Apply.

This procedure describes how to use the front control buttons and LCD to 
configure Transparent mode and Transparent mode IP addresses. Use the 
information you recorded in 

 to complete this procedure.

Press Enter to display the option list.

Use the up or down arrows to highlight Management Interface.

Set the management interface IP address. 

Use the up and down arrow keys to increase or decrease the value of each IP 
address digit. Press Enter to move to the next digit. Press Esc to move to the 
previous digit. 

After you set the last digit of the IP address, press Enter.

Use the down arrow to highlight Netmask. 

Press Enter and set the management IP Netmask.

After you set the last digit of the Netmask, press Enter. 

Press Esc to return to the main menu setting.