Fortinet fortigate-200a Installationsanweisungen

The default gateway is usually configured for the interface connected to the 
Internet. You can use the procedure below to configure a default gateway for any 
interface. 

Press Enter to display the interface list. 

Use the down arrow key to highlight the name of the interface connected to the 
Internet and press Enter. 

Use the down arrow to highlight Default Gateway.

Press Enter and set the default gateway.

After you set the last digit of the default gateway, press Enter.

Press Esc to return to the main menu setting. 

To verify the interface settings entered from the front control buttons and LCD, go 
to the web-based manager, System > Network > Interface. The interface IP 
addresses entered from the front control buttons and LCD should be displayed. 

To verify your connection, try the following:

• browse to www.fortinet.com
• retrieve or send email from your email account

If you cannot browse to the web site or retrieve/send email from your account, 
review the previous steps to ensure all information was entered correctly and try 
again. 

As an alternative to the web-based manager, you can begin the initial 
configuration of the FortiGate unit using the command line interface (CLI). To 
connect to the CLI, see 

. Use the information 

you gathered in 

 to complete the following procedures. 

Note: When you enter the IP address, the LCD always shows three digits for each part of 
the address. For example, the IP address 192.168.100.1 appears on the LCD as 
192.168.100.001. The IP address 192.168.23.45 appears as 192.168.023.045.