Fortinet fortigate-200a Betriebsanweisung

Complete the command with the number of the subordinate unit to log into. For 
example, to log into subordinate unit 1, enter the following command:
execute ha manage 1
Press Enter to connect to and log into the CLI of the selected subordinate unit. If this 
subordinate unit has a different host name, the CLI prompt changes to this host name. 
You can use CLI commands to manage this subordinate unit.

Enter the following command to return to the primary unit CLI:
exit
You can use the execute ha manage command to log into the CLI of any of the 

other subordinate units in the cluster.

You can configure the FortiGate SNMP agent to report system information and send 
traps (alarms or event messages) to SNMP managers. Using an SNMP manager, you 
can access SNMP traps and data from any FortiGate interface or VLAN subinterface 
configured for SNMP management access.

The FortiGate SNMP implementation is read-only. SNMP v1 and v2c compliant SNMP 
managers have read-only access to FortiGate system information and can receive 
FortiGate traps. To monitor FortiGate system information and receive FortiGate traps 
you must compile Fortinet proprietary MIBs as well as Fortinet-supported standard 
MIBs into your SNMP manager.

RFC support includes support for most of RFC 2665 (Ethernet-like MIB) and most of 
RFC 1213 (MIB II) (for more information, see 

This section describes:

•

•

•

•

•

Go to System > Config > SNMP v1/v2c to configure the SNMP agent.