Fortinet fortigate-50r Installationsanweisungen

You can restore system settings by uploading a previously downloaded system 
settings text file:

Go to System > Status.

Select System Settings Restore.

Enter the path and filename of the system settings file, or select Browse and locate 
the file.

Select OK to restore the system settings file to the FortiGate unit.
The FortiGate unit restarts, loading the new system settings.

Reconnect to the web-based manager and review your configuration to confirm that 
the uploaded system settings have taken effect.

Use the following procedure to restore system settings to the values set at the factory. 
This procedure does not change the firmware version or the antivirus or attack 
definitions.

Go to System > Status.

Select Restore Factory Defaults.

Select OK to confirm.
The FortiGate unit restarts with the configuration that it had when it was first powered 
on.

Reconnect to the web-based manager and review the system configuration to confirm 
that it has been reset to the default settings.
To restore your system settings, see 

.

Use the following procedure to switch the FortiGate unit from NAT/Route mode to 
Transparent mode. When the FortiGate unit has changed to Transparent mode its 
configuration resets to Transparent mode factory defaults.

Go to System > Status.

Select Change to Transparent Mode.

Select Transparent in the operation mode list.

Select OK.
The FortiGate unit changes operation mode.

Caution: This procedure deletes all changes that you have made to the FortiGate configuration 
and reverts the system to its original configuration, including resetting interface addresses.