Sonance SILHOUETTE I Installationsanweisungen

5. Using a drywall saw, cut a hole large enough to allow inspection. 

6. Look inside opening and move any fire stops that will interfere with installation. Be sure to replace any fire stops you remove.

7. Cut the drywall and remove.

Speaker grilles may be painted to color match surroundings.

1. First, remove the grille by carefully prying it away from the baffle starting at the short end of the speaker. Prepare both the grille
and speaker frame using a light 600 grade sanding material. The idea is to create a slightly rough surface for the primer to adhere
to. 

2. All sanded surfaces should be cleaned with a soft cloth. Apply a primer such as XIM grade spray primer to all metal surfaces to
be painted. Dry according to the directions provided by the primer manufacturer. After the primer is dry, a light final sanding
should be done to increase the adherence of the paint to the primer. 

3. Prior to painting, all surfaces should be wiped clean with a
dry cloth.

4. Apply the paint with a sprayer if possible creating an even
finish. Additional coats may be desired to achieve the needed
results.

Larger wire than normal is recommended to reduce resistance
and to eliminate power loss between your audio equipment and
your Silhouette speakers.

• 14 gauge for less than 30 feet.

• 12 gauge for between 30 and 75 feet.

• 10 gauge for greater than 75 feet.

If

you have run a single, two conductor wire to each speaker location,
use the positive (+) and negative (-) terminals closest to the outside
edges of the Sonance Silhouette speaker (see figure “A” to right).

If you have run a single, four conductor wire or special bi-wire cable
to take advantage of the bi-wire option (see figure “B” to left), follow
these instructions:

1. Remove the two special jumper wires that cross-connect the four
input terminals on the rear of the Sonance Silhouette speaker. 

2. Attach the two wires you have designated for the woofer and
connect them to the terminals marked woofer. Carefully observe
polarity.

3. Attach the two wires you have designated for the mid-high range to the other set, again being careful to observe proper
speaker to amplifier connection.

1. Make sure wire terminations are correct 2. Rotate all Roto-Lock mounting fasteners around the speaker’s edge to their OPEN position. 

3. Carefully lift the speaker into the wall opening.

4. Use a screwdriver to turn the Roto-Lock mounting fasteners visible in the channel of the extruded aluminum frame into the
CLOSED position. Sonance’s Roto-Lock mounting system firmly attaches the Sonance Silhouette speaker to the wall by means of
a foot that rotates into place, securely clamping the baffle to the mounting surface.

5. Insert the grilles in the groove in the extruded frame starting at one of the short ends and working the grille into the frame. 

Fig. A

2 Wire Connection

Fig. B

4 Wire Bi-Wire Connection