Dwin hd-700 Installationsanweisungen

- 14 -

Press “1” to select “Size”  adjustment

Adjust the height and width by using the 

/ / /  arrow buttons to fill the proper aspect ratio for

your screen.

Tilt adjustments make certain that images are parallel to the edges of the screen, regardless of any
errors that may be induced in the physical installation of the projector. When making  tilt adjustments
you may wish to use a carpenter’s level to make certain that the actual settings are accurate.

At the Tilt adjust screen, use the  /  buttons on the remote to adjust the picture until the vertical line
at the center of the screen is straight up and down.  This line will be indicated by hash-marks.  Use
the 

/  buttons on the remote to adjust the picture until the horizontal line at the center of the

screen is straight across.

Pin adjustments are necessary to ensure that the line indicated by hash-marks is straight at the
edges.  After you've corrected for TILT, press "3" and repeat the procedure for PIN.

Now press "SEL" button to close the cursor square and use the left cursor button to move the cursor
square to the left edge of the screen.

                                        

The left edge line of the screen is now indicated by hash-marks.  Open the cursor by pressing Select
and make the necessary adjustments for both TILT and PIN to the far left edge line.

Press Select again to close the cursor and move to the top of the screen using the 

  arrow key.

Repeat TILT and PIN adjustments.

Repeat TILT and PIN adjustments at the right and bottom edges.

This adjustment permits you to adjust the relationship of the geometry from one side of the picture to
the other.

At the Linearity adjust screen, use the  /  buttons on the remote to adjust the picture until left and
right halves of the picture are equal, and  use  /  buttons  on the remote to adjust the picture until
top and bottom halves are equal.

At this point you may press “8” to proceed with the Red Geometry adjustments, or press “MENU” to
exit.