Dwin hd-700 Installationsanweisungen

- 12 -

Press “1” to view the focus screen. Note that the screen will
display the  Focus menu against a background of the focus
pattern.

Before adjusting focus you may wish to change the signal
level for the on screen test pattern. This adjustment  DOES
NOT affect the actual signal level for picture displays, but it
does allow lower  signal  levels  during  adjustments  so  that
they are more precise. Low levels use  less  beam  current.
This, in turn, means that the video spot size is as small as
possible and is not prone to the softening caused by an over
driven signal.

To change the signal level for focus adjustments, first reach
the  Focus menu as outlined in the steps shown above. At
the  Focus  menu,  press  “5”  to  display  the  Signal  Level
Menu.

       -Focus-
1. Green
2. Red
3. Blue
4. Pattern
5. Signal level

Use the left or right adjustment buttons on the remote (

), increase or decrease the signal level. When you

have reached the desired signal level press “1” to display the Green Focus adjustment screen.
NOTE: Any change to the signal level in this menu will be effective only during focus adjustments. The signal
level will return to normal levels when you return to the Main Menu or cancel the focus adjustment.

Once the signal level has been set, adjust the focus of each color channel using the following steps:

1. From the Focus menu press “1” to display the Green Focus adjustment screen.

2. Adjust the overall optical focus by loosening the wing nut at the rear of the green (center) lens so that it is
loose, but do not remove it. Rotate the lens barrel by holding the lens with one hand and moving the nut
post with the other along the provided track. When the picture is in sharp focus hand tighten the wing nut.

3. Adjust the edge focus by loosening the wing nut closest to the outer edge of the lens, but do not remove
it. Focus the lens by holding the back of the lens with one hand while you rotate the outer barrel with the
other. You may find it easier to grasp the “wings” that protrude up from the barrel to aid in the focus. Tighten
the wing nut when complete.

4. Press “2” on the remote to move to the Red Focus menu. Repeat the procedures in items 2 and 4 above,
adjusting the optical main focus and the optical edge focus for the Red channel.

6. When the Red focus is complete, press “3” to display the  Blue Focus menu. Repeat the procedures in
items 2 and 3 above, adjusting the optical main focus and the optical edge focus for the Blue channel.

7. When these adjustments are complete press the “MENU” button to return to the Focus menu. At this point
you may wish to check the focus using different test patterns. To change the pattern, first press “4” on the
remote. Each subsequent press of the “4” button will change the pattern.

8. When all focus adjustments are complete press “MENU” twice to return to the Adjust menu, or  “EXIT”
button on the remote to exit the menu system.