Bizfon 680 Betriebsanweisung
Appendix A Professional Installation Guide
76
Bizfon , Inc.
Creating a Multibox System from Four Standalone
Units
Units
If you are creating a multi-box installation from standalone
units, follow these steps:
units, follow these steps:
You should be physically at the units as you need to press the
blue buttons when prompted.
blue buttons when prompted.
1. Install each unit as described early.
2. Connect the network cables to the Ethernet hub.
Do NOT connect the expansion cables.
3. Connect each unit to a power source and wait until you hear
“The Bizfon is ready...” Each unit plays this message.
4. Plug a telephone into extension 201 on the unit that will be
Unit 1.
5. Access personal settings.
NOTE: If you have not yet set up the extension, you must
press
before you can access settings.
6. Enter extension 200 and enter the password if required.
7. Press
to configure the multibox system.
8. Press
to continue.
The Bizfon tells you the status of the units.
BizTouch 3: Press SETUP, select
SETTINGS, press ENTER. Phone must
be hung up. If it is not, press FORWARD.
SETTINGS, press ENTER. Phone must
be hung up. If it is not, press FORWARD.
BizTouch 2 or BizTouch 1: Press
SETTINGS.
SETTINGS.
Bizfon conference series phone or non-
BizTouch phone: Press
BizTouch phone: Press
.