Hitachi ed-pj32 Benutzerhandbuch

Troubleshooting

Before requesting repair, please check in accordance with the following chart.

This operation sometimes resolves your problem.

Phenomena that may easily be taken as machine defects

Then, if the problem is not removed after maintenance, please contact your dealer

or service company.

The projector’s microprocessor may need to be reset. Please push the restart

switch by using a pin or similar. (20)

►Never use the projector if abnormal operations such as

smoke, strange odor, excessive sound, damaged casing or elements or cables,

penetration of liquids or foreign matter, etc. should occur. In such cases,

immediately turn off the power switch and then disconnect the power plug from

the power outlet. After making sure that the smoke or odor has stopped, contact

your dealer or service company.

WARNING

If the situation cannot be corrected,

Some setting may be wrong. Please use the FACTORY RESET function of

the SERVICE item in the OPTION menu (46) to reset all settings to factory

default.

Phenomenon

Cases not involving a machine defect

Reference

page

The electrical power cord is not plugged in.

Correctly connect the power cord.

The power switch is not set to the on position.

Set the power switch to [ | ] (On).

The main power source has been interrupted during

operation such as by a power outage (blackout), etc.

Please turn the power off, and allow the unit to cool down at

least 20 minutes. After the projector has sufﬁciently cooled

down, please turn the power on again.

19, 20

The computer cannot detect the projector as a plug

and play monitor.

Make sure that the computer’s can detect a plug and play

monitor using other plug and play monitor.

The signal cables are not correctly connected.

Correctly connect the connection cables.

13, 14

Signal source does not correctly work.

Correctly set up the signal source device by referring to the

manual of the source device.

The input changeover settings are mismatched.

Select the input signal, and correct the setting.

Power does not

come on.

Neither sounds

nor pictures are

outputted.