Canon i560 Anleitung Für Quick Setup

Troubleshooting

Error Writing / 
Output to LPT1 or 
USBxxx (USB 
PRNnn)

Printer not ready

The POWER lamp will flash green when the printer is warming up or when a print 
job is being sent to the printer. It will glow a steady (non-flashing) green when it 
is ready for use or when the print job is completed.

Paper is not loaded

Load paper and press the RESUME/CANCEL button.

Faulty connection

Ensure that the printer cable is securely connected to the computer.

Printer port error

Verify the printer port status.
When using the parallel interface
1. Open the Device Manager, double-click Ports (COM/LPT), then double-click 

Printer Port (LPT1)*.
* The printer port name depends on your system environment.

2. On the Hardware tab, check for any indication of a problem with the port and 

if the connected device is available.

When using the USB interface
Open the Device Manager, double-click Universal Serial Bus (USB) controllers, 
and then double-click Canon i560 to see the status.
Refer to the User's Guide for instructions on how to verify the status.

Printer port 
settings and printer 
interface do not 
match

Confirm that the destination Printer Port is set to LPT1: (ECP printer port), USB 
PRNnn (Canon i560) or USBnnn (Canon i560) (Where n represents a number).
If you find that the settings are not correct, shut down Windows, turn off the 
printer, and reconnect it to the computer with the type of cable that has been set 
in the printer driver. If you are using Windows 95 or Windows NT4.0, you will 
need to reinstall the printer driver. For information about installation of the 
printer driver, refer to the 

Easy Setup Instructions. 

Refer to the 

User’s Guide for instructions on how to verify status and the correct 

action to take.

Printer driver is not 
installed properly

Uninstall then reinstall the printer driver.
1. Click Start, and select All Programs (or Programs), Canon i560, and Uninstall.

2. Follow the on-screen instructions to uninstall driver.

3. Follow the procedures described in the 

Easy Setup Instructions and reinstall 

the printer driver.

“Error No.: X202” 

Not enough 
memory

Increase available memory by closing any other applications currently running.

“Error No.: X203” 

Printer driver fault

Uninstall, then reinstall printer driver.
Refer to the 

User’s Guide for instructions on how to uninstall the printer driver.

Note

If you are using switching hub or other device, disconnect the 
printer and reconnect it directly to the computer and try 
printing again.
If successful, the problem may have been with the device.
There could also be a problem with the cable(s). Replace the 
cable(s) and try printing again.

i560_QSG_US.book  Page 53  Tuesday, May 6, 2003  1:43 PM