LXE mx7 Verweisanleitung
LXE Scanner Wedge
329
E-EQ-MX7RG-H
MX7 Reference Guide
Factory Default Settings
Factory Default Settings
Main
Port 1
Port 1
Internal
Port 2
Disabled
Port 3
Disabled
Send key messages (WEDGE)
Enabled
Enable Internal Scanner
Sound
Sound
Enabled
Good Scan Vibration
Disabled / Long
Bad Scan Vibration
Disabled / Long
COM1 Port (external serial port)
Baud Rate
Baud Rate
9600
Stop Bits
1
Parity None
Data Bits
Data Bits
8
Barcode
Use Advanced Barcode Processing
Use Advanced Barcode Processing
Disabled
Scanner Control Panels
If “Send Key Messages …” is checked any data scan is converted to keystrokes and sent to the
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using “Wedge”. Even if Send Key Messages is enabled (key mode), the
data is still available using the scanner APIs (block mode).
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using “Wedge”. Even if Send Key Messages is enabled (key mode), the
data is still available using the scanner APIs (block mode).
Disable “Enable Internal Scanner Sound” when you want an application, not the scan engine or
the CE operating system, to control scanner audible notifications. Adjust the settings and tap the
OK box to save the changes. This change takes effect immediately.
the CE operating system, to control scanner audible notifications. Adjust the settings and tap the
OK box to save the changes. This change takes effect immediately.