LXE mx7 Verweisanleitung

334 

LXE Scanner Wedge 

MX7 Reference Guide 

 

E-EQ-MX7RG-H 

4. 

Since the assigned replacements are applied before the Translate All is performed, if a 
control character is set to ‘Ignore (drop)’ by the assigned replacements, it is discarded 
before the Translate All processing is performed and is therefore not translated. 

5. 

Since the assigned replacements are applied before the Translate All is performed, if a 
control character is set to text by the assigned replacements, the text is substituted for the 
control character. In this case, the control character would not be in the data processed by 
the Translate All feature. 

6. 

If the application that is accessing the Barcode Wedge in Block mode, supports Hat 
encoded characters, like ^M, hat encoded characters can be assigned in the defined action 
and then interpreted by the receiving application by using the ‘escape’ format described 
above. The same is true for hex-encoded characters. 

 

   

   

    

Note that Control Character Mapping is available regardless of the status of the Use Advanced 
Barcode Processing checkbox.  

See “Hat Encoding” and “Decimal-Hexadecimal Chart” in Appendix B. 

If “Translate All” is checked, unprintable ASCII characters (characters below 20H) in scanned 
barcodes are assigned to their appropriate CTRL code sequence when the barcodes are sent in 
Character mode.  

When “Translate All” is not checked and “Send Key Messages” is checked, CTRL codes are 
passed through in Block mode. 

The wedge provides a one-to-one mapping of control characters to their equivalent 
control+character sequence of keystrokes in Key Message mode. If a control character is replaced