LXE mx7 Verweisanleitung

332 

LXE Scanner Wedge 

MX7 Reference Guide 

 

E-EQ-MX7RG-H 

Prefix / Suffix is only available when Use Advanced Barcode Processing is disabled (default).  

   

   

    

Prefix/Suffix (and pre-existing data) is ignored when Use Advanced Barcode Processing is 
enabled. 

This feature, when enabled, strips the specified number of characters from a barcode, either from 
the beginning (leading) or at the end (trailing), or both.  

When this feature and the Add Prefix and / or Add Suffix features are both enabled, the leading 
and trailing characters are stripped before the prefix or suffix is appended.  

The configuration for stripping leading and trailing characters is specified independently. To 
enable, either or both of the checkboxes labeled Strip Leading and Strip Trailing must be checked. 
Then the number of characters to be stripped can be typed into the edit control or set using the 
spin control on the right of the edit control.  

The maximum number of characters that can be stripped is 99 characters for each leading and 
trailing number of characters. When the Strip Leading and Strip Trailing checkboxes are blank (or 
disabled), the edit controls are disabled; however the last specified number of characters to strip is 
retained and dimmed. 

When the number of characters to be stripped is greater than the number of characters in the 
barcode a good read beep is sounded but all barcode data is discarded. 

If Add Prefix and / or Add Suffix are combined with Strip Leading and / or Strip Trailing, the 
leading and / or trailing characters are stripped before the prefix or suffix is added. 

The mode for Prefix/Suffix feature is determined by the “Send Key Messages (WEDGE)” setting 
in the Main tab. When checked (enabled), the prefix/suffix feature is in 

. Key