LXE mx7 Verweisanleitung
24
Client and Network Setup
MX7 Reference Guide
E-EQ-MX7RG-H
Applying the Protective Film to the Display
First, clean the display of fingerprints, lint particles, dust and smudges.
Remove the protective film from its container. Remove any protective backing from the film sheet
by lifting the backing from a corner of the film. Discard the backing.
by lifting the backing from a corner of the film. Discard the backing.
Apply the film to the screen starting at one side and smoothing it across the display. If air bubbles
appear, raise the film slightly and continue smoothing the film across the display until it covers
the glass surface of the display.
appear, raise the film slightly and continue smoothing the film across the display until it covers
the glass surface of the display.
If dust, lint or smudges are trapped between the protective film and the glass display, remove the
protective film, clean the display and apply the protective film again.
protective film, clean the display and apply the protective film again.
Client and Network Setup
Prerequisites
•
Network SSID or ESSID number of the Access Point
•
WEP or LEAP Authentication Protocol Keys
Note:
If the access point uses authentication protocol (LEAP, WEP etc.) your network card
must use the same authentication keys. Please contact your IS department for WEP or
LEAP encryption keys before contacting LXE. WEP and LEAP are authentication
protocols used to encrypt data sent and received from the mobile device to the access
point. WEP is disabled by default.
must use the same authentication keys. Please contact your IS department for WEP or
LEAP encryption keys before contacting LXE. WEP and LEAP are authentication
protocols used to encrypt data sent and received from the mobile device to the access
point. WEP is disabled by default.
Note: The MX7 may use either the Funk Odyssey Client or the Summit Client Utility to
configure the network card.
When the MX7 boots up for the first time and all programs are loaded, the Wireless Information
window may appear. The client is attempting to connect to the local network.
window may appear. The client is attempting to connect to the local network.
Please refer to Chapter 5 “Wireless Network Configuration” to continue setting up the client and
network.
network.