LXE mx7 Verweisanleitung
38
Entering Data
MX7 Reference Guide
E-EQ-MX7RG-H
Scan Status LED
Figure 1-28 Scan Status LED
The Scan Status LED (oval shaped LED below keypad) turns red when the laser beam is on.
Following a barcode scan and read the Scan Status LED turns green for two seconds and the MX7
beeps or vibrates, indicating a successful scan. If the scan was unsuccessful, the Scan Status LED
turns off and a different beep sequence is heard.
Following a barcode scan and read the Scan Status LED turns green for two seconds and the MX7
beeps or vibrates, indicating a successful scan. If the scan was unsuccessful, the Scan Status LED
turns off and a different beep sequence is heard.
The laser engine and Scan Status LED automatically turn off after a successful or unsuccessful
read. The scanner / imager is ready to scan again after the Scan key (or trigger on the handle if
installed) is released, or after the Scan Status LED turns off following a successful scan.
read. The scanner / imager is ready to scan again after the Scan key (or trigger on the handle if
installed) is released, or after the Scan Status LED turns off following a successful scan.
The Scan Status LED turns amber when scanner/imager programming changes, if any, are being
saved. When the LED is off, the MX7 is ready to scan again.
saved. When the LED is off, the MX7 is ready to scan again.
Tethered Scanners
Tethered scanners cabled to the MX7 I/O port are not supported by LXE. Tethered scanners
cabled to the MX7 Cradle I/O port are supported by LXE, see “MX7 Cradle Reference Guide”
for instruction.
cabled to the MX7 Cradle I/O port are supported by LXE, see “MX7 Cradle Reference Guide”
for instruction.
Bluetooth Scanners and Printers
Note:
Barcode manipulation parameters in Chapter 4 – Scanner are applied to the incoming
data resulting from successful barcode scans sent to the MX7 for processing.
data resulting from successful barcode scans sent to the MX7 for processing.
Bluetooth scanners are paired to the MX7 wirelessly using the MX7 Bluetooth wireless client.
The MX7 does not have a Bluetooth LED.
The MX7 does not have a Bluetooth LED.
See previous section Bluetooth for more information.
Only LXE Bluetooth scanners and LXE Bluetooth printers are supported by LXE. See
Accessories.
Accessories.
Voice Data
Data is entered into the MX7 by speaking into the headset’s microphone when prompted. Please
contact your System Administrator if assistance is needed with the voice software.
contact your System Administrator if assistance is needed with the voice software.