LXE mx7 Verweisanleitung

Flash Cards 

51 

E-EQ-MX7RG-H 

 

MX7 Reference Guide 

Equipment required:  None 

• 

LXE recommends that installation/removal of cards be performed on a clean, well-lit 
surface.  

• 

Anti-static protection is required when installing/removing cards. (Not supplied by LXE) 

• 

If you anticipate keeping a card out of the MX7 for a long period of time place it in a 
static-free storage container. Store in an area that is protected from dirt, moisture, and 
electrostatic contact. 

1.  Place the MX7 into Suspend Mode. Disconnect the AC adapter from the MX7. 
2.  Loosen then remove the main battery pack. 
3.  Lift the rubber barrier and hold it aside. Do not remove it from the battery well. 
4.  Slide the flash card into the recessed slot, label side uppermost, until it clicks into place. 
5.  Replace the rubber barrier and the main battery pack and perform a warm reset. Always 

perform a warm reset when exchanging one Flash card for another.  

1.  Place the MX7 into Suspend Mode. Disconnect the AC adapter from the MX7. 
2.  Loosen then remove the main battery pack.  
3.  Lift the rubber barrier and hold it aside. Do not remove it from the battery well. 
4.  Carefully slide the flash card out and away from the recessed slot.