LXE mx7 Verweisanleitung
Physical Controls
49
E-EQ-MX7RG-H
MX7 Reference Guide
Physical Controls
Power Key
Note:
Refer to the section titled “Power Modes” for information relating to the power states of
the MX7.
the MX7.
The power key is located next to the < Z > key on the 55-key keypad and next to the <Diamond
2> key on the 32-key keypad. When a main battery pack is inserted in the MX7 for the first time,
the Power key must be pressed.
2> key on the 32-key keypad. When a main battery pack is inserted in the MX7 for the first time,
the Power key must be pressed.
Quickly tapping the Power key places the MX7 immediately in Suspend mode. Quickly tapping
the Power key again, pressing any key, pressing the trigger (on the trigger handle), or tapping the
touchscreen, immediately returns the MX7 from Suspend.
the Power key again, pressing any key, pressing the trigger (on the trigger handle), or tapping the
touchscreen, immediately returns the MX7 from Suspend.
The System LED blinks green when the video display is Off.
Note:
The unit will suspend on AC power and when connected through ActiveSync. Remember
to set the suspend timers before using ActiveSync.
to set the suspend timers before using ActiveSync.
When the Windows CE desktop is displayed or an application begins, the power up (or reboot)
sequence is complete. If you have previously saved your settings, they will be restored on reboot.
Application and control panel applet changes are saved when OK is tapped on an application
applet.
sequence is complete. If you have previously saved your settings, they will be restored on reboot.
Application and control panel applet changes are saved when OK is tapped on an application
applet.
The Process
The MX7 reloads the operating system upon every warm boot or cold boot. Anything not saved or
preserved to the registry is lost.
preserved to the registry is lost.
In warm boot, the OS and the CAB files are reloaded from the internal SD card and the preserved
registry is also reloaded.
registry is also reloaded.
During cold boot, the system behavior is identical to warm boot with the addition that the registry
is reloaded with factory defaults.
is reloaded with factory defaults.
Warm Reset
Hold down the Power key for 15 seconds until the display blanks, then release the key. A warm
reset does not affect the operating system but data in SDRAM is lost. Data saved to the SD card is
not lost. Network connection will need to be re-established.
reset does not affect the operating system but data in SDRAM is lost. Data saved to the SD card is
not lost. Network connection will need to be re-established.
Or, using the input panel, you can tap
| Run and type WARMBOOT
. Tap the OK button.
Cold Reset
Important:-- Because of the extreme nature of the Cold Reset, LXE recommends that
the Cold Reset be used only as an emergency procedure and the Warm Reset be used
whenever necessary.
Tap
| Run and type COLDBOOT
1
.
Tap the OK button to coldboot the MX7. The default
settings are restored when the device powers on again. Calibrating the touchscreen will need to be
performed when the cold boot process is complete (OS versions released before August 2008
only).
performed when the cold boot process is complete (OS versions released before August 2008
only).
2
This command filename is not case-sensitive.