LXE mx6 Verweisanleitung
Power Tools EZConfig Utilities
207
E-EQ-MX6RG-E
MX6 Reference Guide
Key Value
Description
BadScanWav
Default=””
Specifies a wave file to be played on an
unsuccessful decode/data reception. The wave file
should be an 8 bit, 11KHz, mono, PCM file. If no
wave file is specified, the default beep will be
utilized. Use the ‘sound’ setting to enable and
disable audio notification. NOTE: The Window's
“Bad Decode” sound defined in the control panel
or the BadScanFreq parameter take precedence
over this option, if defined.
unsuccessful decode/data reception. The wave file
should be an 8 bit, 11KHz, mono, PCM file. If no
wave file is specified, the default beep will be
utilized. Use the ‘sound’ setting to enable and
disable audio notification. NOTE: The Window's
“Bad Decode” sound defined in the control panel
or the BadScanFreq parameter take precedence
over this option, if defined.
GoodScanLen 50
Number
of
milliseconds to play the sound as
specified in GoodScanFreq.
GoodScanFreq
2794
Sound frequency used for playing a custom good
scan beep. NOTE: The Window's “Good Decode”
sound defined in the control panel takes
precedence over this option, if defined.
scan beep. NOTE: The Window's “Good Decode”
sound defined in the control panel takes
precedence over this option, if defined.
BadScanLen 25
Number
of
milliseconds to play the sound as
specified in BadScanFreq
BadScanFreq
523
Sound frequency used for playing a custom bad
scan beep. NOTE: The Window's “Bad Decode”
sound defined in the control panel takes
precedence over this option, if defined.
scan beep. NOTE: The Window's “Bad Decode”
sound defined in the control panel takes
precedence over this option, if defined.
ResetIdleTimers
0
If set to 1, resets the Window's Idle timers before
each decode attempt, preventing the device from
entering into suspend mode when in AutoScan
mode.
each decode attempt, preventing the device from
entering into suspend mode when in AutoScan
mode.
AudioMode 1