Ricoh 2035e Benutzerhandbuch

Appendix

110

This section describes the main possible causes and actions for error messages
displayed on the client computer when the TWAIN driver is used.

r If an error message that is not contained in this section appears, turn off the

main power switch of the machine, and then turn it on again. If the message
is still shown after scanning is performed again, note the content of the mes-
sage and the error number (if listed in the table), and contact your service rep-
resentative. For information about how to turn off the main power switch, see
General Settings Guide.

The entered path is not correct. 

Please re-enter.

Make sure the computer for destina-
tion and the path, and then enter if 
again.

The specified group contains some 

invalid destination(s).

Do you want to select only valid des-

tination(s)?

The specified group contains some 
destinations for sending by e-mail 
and sending by Scan to Folder. To se-
lect destinations for sending by e-
mail, press 

 for the warning 

displayed on the e-mail screen. To 
select destination for sending by 
Scan to Folder, press 

 for the 

warning displayed on the Scan to 
Folder screen.

Updating the destination list. Please 

wait. Specified destination(s) or 

sender's name has been cleared.

If a destination or sender's name was 
already selected, re-select it after this 
message disappeared.

Updating the destination list has 

failed. Try again?

Check whether the server is connect-
ed.

The maximum number of modes that can 
be stored is 99. Delete unneeded modes.

The access mask is set. Consult the network 
or scanner administrator.

• Place the original correctly.

• Specify the scan size.

• When placing an original directly on the 

exposure glass, the lifting/lowering ac-
tion of the ADF triggers the automatic 
original size detection process. Lift the 
ADF by more than 30 degrees.