Ricoh sp 3200sf Benutzerhandbuch

5.7   

<Loading originals and print media>

The multi-purpose tray can hold special sizes and types of print material, 
such as transparencies, postcards, note cards, and envelopes. It is useful 
for single page printing on letterhead or colored paper. 

To load paper in the multi-purpose tray:

Open the multi-purpose tray and unfold the multi-purpose tray 
extension, as shown. 

If you are using paper, flex or fan the edge of the paper stack to 
separate the pages before loading.

For transparencies, hold them by the edges and avoid touching the 
print side. Oils from your fingers can cause print quality problems. 

Load the paper with the side to be printed on facing up.

Squeeze the multi-purpose tray paper width guides and adjust them 
to the width of the paper. Do not force too much, or the paper will be 
bent, which will result in a paper jam or skew.

After loading paper, set the paper type and size for the multi-
purpose tray. See page 5.8 for copying and faxing or the Software 
section for PC-printing. 

After printing, fold the multi-purpose tray extension and close the 
multi-purpose tray.

Depending on the media type you are using, keep the following 
loading guidelines:
• Envelopes: Flap side down and with the stamp area on the top 

left side.

• Transparencies: Print side up and the top with the adhesive 

strip entering the machine first.

• Labels: Print side up and top short edge entering the machine 

first.

• Preprinted paper: Design side up with the top edge toward the 

machine.

• Card stock: Print side up and the short edge entering the 

machine first.

• Previously printed paper: Previously printed side down with an 

uncurled edge toward the machine.

• The settings made from the printer driver override the settings 

on the control panel.

• Make sure to open the rear cover when you print on 

transparencies. If not, they may tear while exiting the machine.