Ricoh CL5000 Installationsanleitung
Options
36
1
1394 Interface Unit Type 4510
R CAUTION:
Important
❒ Printing using "1394/Scsi Printer
"(Windows 2000) device and "IEEE
1394 and SCSI printers" (Windows
XP) with the optional 1394 Inter-
face Unit is possible under Win-
dows 2000 and Win dow s X P.
Printing with IP over 1394 is possi-
ble under Windows Me and Win-
dows XP.
1394 and SCSI printers" (Windows
XP) with the optional 1394 Inter-
face Unit is possible under Win-
dows 2000 and Win dow s X P.
Printing with IP over 1394 is possi-
ble under Windows Me and Win-
dows XP.
❒ Under Windows 2000, the 1394 In-
terface Unit can only be used with
Service Pack 1 or later. If the Ser-
vice Pack is not installed, the con-
nectable SCSI print device in a
1394 bus is only one. The client
cannot install the printer driver
without using an account with Ad-
ministrators permission.
Service Pack 1 or later. If the Ser-
vice Pack is not installed, the con-
nectable SCSI print device in a
1394 bus is only one. The client
cannot install the printer driver
without using an account with Ad-
ministrators permission.
❒ Before touching the 1394 Interface
Unit, touch something metal to
discharge any static electricity.
Static electricity can damage the
1394 Interface Unit
discharge any static electricity.
Static electricity can damage the
1394 Interface Unit
❒ Unplug all the interface cables
from the printer before installa-
tion. If you take out the controller
board with cables plugged in, the
1394 Interface Unit might be dam-
aged.
tion. If you take out the controller
board with cables plugged in, the
1394 Interface Unit might be dam-
aged.
❒ Do not plug or unplug the 1394 in-
terface cable while installing the
printer driver
printer driver
❒ Use the 1394 Interface cable that
comes with 1394 Interface Unit.
AAAA
Check the contents.
❖
❖
❖
❖ 1394 Interface Unit Type 4510
❖
❖
❖
❖ Interface Cable (6 pin ×××× 6 pin)
❖
❖
❖
❖ Interface Cable (6 pin ×××× 4 pin)
Note
❒ The four screws and the sponge
supplied are not to be used.
BBBB
Turn off the power switch, and
then unplug the power cable and
the interface cable.
then unplug the power cable and
the interface cable.
• Do not touch the inside of the
controller board compartment. It
may cause a machine malfunc-
tion or a burn.
may cause a machine malfunc-
tion or a burn.