Ricoh cl7000 Bedienungsanleitung
Operating Instructions
Administrator Reference
212
ROUTE
Use the “route” command to control the routing table.
This command allows you to configure and display routing information. You can change the network
configuration from a remote computer using this command.
configuration from a remote computer using this command.
Note
❒
The maximum number of routing tables are 16.
*1
IP address
Parameter
Topics of setting
route add {host | net} destination
gateway
gateway
Adds a host/network route to “destination”, and a gateway address to “gateway”
in the table. Host becomes the default setting.
in the table. Host becomes the default setting.
route delete {host | net} destina-
tion
tion
Deletes a host/network route from the table. Host becomes the default setting.
route get {destination}
Displays only route information corresponding to a specified destination. When
the destination is unspecified, all routing information is displayed.
the destination is unspecified, all routing information is displayed.
on/off
You can turn the specified destination on or off. Host becomes the default set-
ting.
ting.
route add default gateway
You can set the default gateway address.
route flush
Deletes all routing information.