Ricoh cl7000 Guia De Utilização

Use the “route” command to control the routing table.

This command allows you to configure and display routing information. You can change the network
configuration from a remote computer using this command.

❒

The maximum number of routing tables are 16.

*1

IP address

route add {host | net} destination 
gateway

Adds a host/network route to “destination”, and a gateway address to “gateway” 
in the table. Host becomes the default setting.

route delete {host | net} destina-
tion

Deletes a host/network route from the table. Host becomes the default setting.

route get {destination}

Displays only route information corresponding to a specified destination. When 
the destination is unspecified, all routing information is displayed.

route active {host | net} destina-
tion 

 on/off

You can turn the specified destination on or off. Host becomes the default set-
ting.

route add default gateway 

You can set the default gateway address.

route flush

Deletes all routing information.