Frigidaire FGEF306TMF Betriebsanweisung

Seite von 36
28
CARE & CLEANING (Cleaning Chart)
CLEANING VARIOUS PARTS OF YOUR APPLIANCE
Before cleaning any part of the appliance, be sure all controls are turned off and the appliance is COOL. REMOVE 
SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF 
MAJOR CLEANING LATER.
Surfaces
How to Clean
Aluminum (trim pieces) & 
Vinyl
Use hot, soapy water and a cloth. Dry with a clean cloth.
Glass, Painted and Plastic 
Body Parts, Control Knobs 
& Decorative Trim Pieces
Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of vinegar 
and water. Follow by rinsing the area with clean water; dry and polish with a soft cloth. 
Glass cleaners may be used if sprayed on a soft cloth fi rst. DO NOT spray liquids directly 
on the control pad and display area. Do not use large amounts of water on the control 
panel - excess water on the control area may cause damage to the appliance. Do not 
use other liquid cleaners, abrasive cleaners, scouring  pads, or paper towels - they will 
damage the fi nish. To remove control knobs, turn to the OFF position; grasp fi rmly and 
pull straight off the shaft. To replace knobs after cleaning, line up the fl at sides of both 
the knob and the shaft; then push the knob into place.
Control Panels
Before cleaning the control panel, turn all controls to OFF and remove the control 
knobs. To remove, pull each knob straight off the shaft. Clean as instructed above. 
Squeeze excess water from the cloth before wiping the panel; especially when wiping 
around the controls. Excess water in or around the controls may cause damage to the 
appliance. To replace knobs after cleaning, line up the fl at sides of both the knob and 
the shaft; then push the knob into place.
Porcelain Enamel
Burner Grates, Cooktop 
Surface, Below Cooktop, 
Broiler Pan & Insert (some 
models), Door Liner, Oven 
Bottom & Burner Drip Pans
Clean burner grates, broiler pan and insert (some models) in the dishwasher and dry 
upon removal. If soils are not removed, follow the cooktop cleaning instructions below.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 
1:1 solution of clear water and ammonia. If necessary, cover diffi cult spots with an 
ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp 
cloth, then scrub with a soap-fi lled scouring pad. Rinse and wipe dry with a clean cloth. 
Remove all cleaners or the porcelain may become damaged during future heating. DO 
NOT use spray oven cleaners on the cooktop.
Easy Care™ Stainless
Steel Oven Door and 
Decorative Trim
Your range fi nish is made with Easy Care™ Stainless Steel. Clean the stainless with 
warm soapy water using a clean sponge or cloth. Rinse with clean water and dry with a 
soft clean cloth. DO NOT use ANY store bought cleaners like Stainless Steel cleaners or 
any other types of cleaners containing any abrasive, chlorides, chlorines or ammonia. 
It is recommended to use mild dish soap and water or a 50/50 solution of water and 
vinegar.
Oven Racks
Remove racks. See “To remove and to replace an oven rack” under Oven vent(s) and 
racks. Use a mild, abrasive cleaner, following manufacturer’s instructions. Rinse with 
clean water and dry. After cleaning the racks, rub the sides of the racks with wax paper 
or a cloth containing a small amount of baby oil or salad oil (this will make the racks 
glide easier into the rack positions).
Oven Door
DO HAND 
CLEAN FRAME
DO NOT HAND 
CLEAN OVEN 
DOOR GASKET
DO HAND 
CLEAN DOOR
Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse 
well. You may use a glass cleaner on the outside glass of the oven door. DO NOT 
immerse the door in water. DO NOT spray or allow water or the glass cleaner to enter 
the door vents. DO NOT use oven cleaners, cleaning powders or any harsh abrasive 
cleaning materials on the outside of the oven door.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven 
material, on Self-Cleaning models, which is essential for a good seal. Care should be 
taken not to rub, damage or remove this gasket.