Frigidaire fgef304dk Betriebsanweisung

9



See Recommended Setting for Surface Element table on 

page 7.

The cooktop has 2 SINGLE radiant surface elements: the 

left rear position and the right rear position (Figure 1).

1.  Place correctly sized cookware on the radiant surface 

element.

2.  Push in and turn the surface control knob in either 

direction to the desired setting (Figure 2). Start most 

cooking operations on a higher setting and then turn 

to a lower setting to fi nish cooking. Each surface 

element provides a constant amount of heat at each 

setting. A glowing red surface heating area extending 

beyond the bottom edge of the cookware indicates 

the cookware is too small for the surface heating 

area.

3.  When cooking has completed, turn the surface 

control knob to OFF before removing the cookware.

Radiant surface elements may appear to have cooled 

after they have been turned OFF. HE (Hot Element) 

message will turn ON and will continue to glow until 

the glass cooktop has cooled down to a moderate 

level. The glass surface may still be hot and burns 

may occur if the glass surface is touched before the 

indicator light has turned OFF. The message may 

remain on even though the controls are turned OFF.

wrappings on cooktop when it is in use. These 

items could melt or ignite. Potholders, towels or 

wooden spoons could catch fi re if placed too close to 

the surface elements.

cooktop. If these items melt on the cooktop they will 

damage the ceramic cooktop.

Figure 2 - Control knob shown is typical only.