Frigidaire fgf379wesr Installationsanweisungen

Some models are equipped with an optional spice rack.

Follow the instructions below for installation:

a. Using a 1/4" nutdriver or Phillips screwdriver, remove

four (4) screws from rear of range as shown in diagram

below.

b. Using these four (4) screws, attach two (2) support

posts (provided) to rear of range.

c. Set rack on support posts and make sure rear end

flanges are around support posts as shown.

Level the range by placing a level horizontally on an oven

rack. Check diagonally from front to back, then level the

range by either adjusting the leveling legs or by placing

shims under the corners of the range as needed.

For porcelain enamel ovens, the serial plate is located on

the right-hand surface of the oven front frame in the broiler

or storage drawer area.

For continuous clean ovens, the serial plate is located on

the right front edge of the floor shield located in the broiler

compartment.

When ordering parts for or making inquires about your

range, always be sure to include the model and serial

numbers and a lot number or letter from the serial plate on

your range.

Your serial plate also tells you the rating of the burners,  the

type of fuel and the pressure the range was adjusted for

when it left the factory.

Read the Avoid Service Checklist and operating instructions

in your Owner's Guide. It may save you time and expense.

The list includes common occurrences that are not the

result of defective workmanship or materials in this

appliance.

Refer to the warranty in your Owner's Guide for our toll-free

service number and address. Please call or write if you have

inquiries about your range product and/or need to order

parts.

Refer to the Owner's Guide for cleaning instructions.

If removing the range is necessary for cleaning or

maintenance, shut off gas supply. Disconnect the gas and

electrical supply. If the gas or electrical supply is inaccessible,

lift the unit slightly at the front and pull out away from the

wall. Pull only as far as necessary to disconnect the gas and

electrical supply. Finish removing the unit for servicing and

cleaning.  Reinstall in reverse order making sure to level the

range and check gas connections for leaks. See page 3,

step 1 for proper anchoring instructions.