Frigidaire fgf379wesr Installationsanweisungen

This range is equipped with sealed burners as shown

below.

Your range may be equipped with either trim rings or

burner pans, or trim rings and burner pans. Install pans

(some models) and trim rings (some models) as follows:

Operation of electric igniters should be checked after range

and supply line connectors have been carefully checked for

leaks and range has been connected to electric power. To

check for proper lighting, push in and turn a surface burner

knob to the LITE position. You will hear the igniter sparking.

The surface burner should light when gas is available to the

top burner. Each burner should light within four (4) seconds

in normal operation after air has been purged from supply

lines. Visually check that burner has lit. Once the burner

lights, the control knob should be rotated out of the LITE

position. There are separate ignition devices for each

burner. Try each knob separately until all burner valves have

been checked.

Note: Knob styles may vary from those pictured below.

a) Turn control to LITE until burner ignites.

b) Quickly turn knob to LOWEST POSITION.

c) If burner goes out, readjust valve as follows:

Reset control to OFF. Remove the surface burner control

knob, insert a thin-bladed screw driver into the hollow

valve stem and engage the slotted screw inside. Flame size

can be increased or decreased with the turn of the screw.

Adjust flame until you can quickly turn knob from LITE to

LOWEST POSITION without extinguishing the flame. Flame

should be as small as possible without going out.

Note:  Air mixture adjustment is not required on surface

burners.