Frigidaire gles388dsb Betriebsanweisung

Push buttons or pads may be shaped differently.

 

 

 

 for 6 seconds

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

1.

Press 

.  "CLO" will appear in the display (Figure 2).

2.

Press 

 

 

 pads to set the time of day to 1:30 (Figure 3).

"CLO" will appear in the display.  Press 

 . "CLO" will

disappear and the clock will start (Figure 4).

1.

Press and hold 

 for 6 seconds (Figure 3). While holding the

pad down the current time of day will remain and "CLO" will
disappear from the display (Figure 4). CONTINUE holding the pad
until a beep is heard.

2.

The display will show either "12Hr" (Figure 5) or "24Hr" (Fig.6).

3.

Press 

 to switch between the 12 and 24 hour time of day

display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).

4.

Press 

 to accept the change or press 

 to reject the

change.

5.

Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.

The 

 pad is used to set the clock. The clock may be set for 12 or 24 hour time of day

operation.  The clock has been preset at the factory for the 12 hour operation.  When the
range is first plugged in, or when the power supply to the range has been interrupted, the timer
in the display will flash with "PF" (power failure, See Figure 1).

When PF appears in the display, press 

.

 No sound will be heard, but after 10 seconds a

beep will sounds and PF will disappear.