Arturia cs-80v Benutzerhandbuch
ARTURIA – CS-80V – USER’S MANUAL
37
5 USING THE CS-80V
5.1 S
INGLE MODE
When the Multi mode hatch is closed, the CS-80V is in «Single» mode. In this mode, the
8 polyphonic voices available are set with the same sound. The sound that is used
8 polyphonic voices available are set with the same sound. The sound that is used
corresponds to the settings of the controls apparent in the graphical user interface.
Multi mode hatch closed
This mode should be selected if you require the same manner of use as the original CS-
80.
80.
5.2 T
WO LINES OF SYNTHESIS
The original CS-80 has a particular structure. Unlike many synthesizers of that time it
used 2 independent generators of subtractive synthesis, each one with an oscillator, a
used 2 independent generators of subtractive synthesis, each one with an oscillator, a
filter and an amplifier. These two lines of synthesis are managed by the central part of
the interface in two parallel groups of controls.
the interface in two parallel groups of controls.
Control of the two lines of synthesis
On each line of synthesis, there is an oscillator that can generate square, triangle, saw
tooth, and sine signals. The first switch activates the square signal, while the second
activates the second waveform, which can be either a triangular signal or a saw tooth.
activates the second waveform, which can be either a triangular signal or a saw tooth.
Selection of waveform
To select the sine, first validate that the linear «~» slider (it must light on) and then set
its volume with this slider.
its volume with this slider.
The square and triangle signals are affected by the pulse width settings noted «PW». The
fader is used to choose a pulse width from 50% to 90%. This pulse width can be
modified by a low frequency oscillator (LFO). The modulation rate is set with the «PWM»
modified by a low frequency oscillator (LFO). The modulation rate is set with the «PWM»
fader, and the speed with the speed fader.