Arturia cs-80v Manual De Usuario

 

37

 

When the Multi mode hatch is closed, the CS-80V is in «Single» mode. In this mode, the 
8 polyphonic voices available are set with the same sound. The sound that is used 

corresponds to the settings of the controls apparent in the graphical user interface. 
 

 

 

This mode should be selected if you require the same manner of use as the original CS-
80. 

 
 

 

The original CS-80 has a particular structure. Unlike many synthesizers of that time it 
used 2 independent generators of subtractive synthesis, each one with an oscillator, a 

filter and an amplifier. These two lines of synthesis are managed by the central part of 
the interface in two parallel groups of controls. 

 

 

 

 
On each line of synthesis, there is an oscillator that can generate square, triangle, saw 

tooth, and sine signals. The first switch activates the square signal, while the second 
activates the second waveform, which can be either a triangular signal or a saw tooth. 

 

 

 

To select the sine, first validate that the linear «~» slider (it must light on) and then set 
its volume with this slider.  

 
The square and triangle signals are affected by the pulse width settings noted «PW». The 

fader is used to choose a pulse width from 50% to 90%. This pulse width can be 
modified by a low frequency oscillator (LFO). The modulation rate is set with the «PWM» 

fader, and the speed with the speed fader.