Nortel 4000 Zusätzliches Handbuch
![Nortel](https://files.manualsbrain.com/attachments/41d8158aa9dad39109585817452a5513bedfdded/common/fit/150/50/b0df237683acfcba182fca1886fb0237fc1e06fba6e3e77a0d64d1463e4c/brand_logo.jpeg)
Configuring the Software
303321-A Rev. 00
3-3
Configuring the Network Adapters and Protocols
1.
Go to
Network Control Panel
.
2.
Select the
Adapters
tab. You should then see a list of
Network Adapters
(i.e., cards) currently configured (e.g., the first span is represented by
NMS
TXn000 LAN adapter <CP.1>
, the second span is represented by NMS
TXn000 LAN adapter <CP.2>
, etc.).
3.
Click on
Add
to add the new card you want to configure.
You will then see the Select Network Adapter screen.
4.
Click on
Have Disk
and type
c:\txnicdrv
.
5.
Make sure the
NMS TXn000 Communications Processor
is highlighted and
then click on
OK
.
The Select NMS Communications Processor dialog box opens. This dialog
box only shows the board address for the TX-2000 board previously installed.
box only shows the board address for the TX-2000 board previously installed.
Figure 3-2.
Select NMS Communications Processor Screen with
Previous Board
Previous Board
6.
Select the board to use and then click on
Select
.
The Select NMS Products to Install/Configure dialog box opens.
7.
Select
TCP/IP Local Area Network Interface
and then click on
OK
.
The TXn000 [CP.n] NCPI LAN Driver Configuration dialog box opens. There
are no changes needed in this dialog box.
are no changes needed in this dialog box.