Exile Audio s250.1 Betriebsanweisung

© 2008 Exile Car Audio • www.exileaudio.com

Amplifier Manual

Connect preamp signal cables from the head unit to these terminals.

Provides a full range signal for an additional amplifier. There is no signal loss if using this 
output.

Controls the lowpass crossover point for the speaker outputs. 

Variable bass boost from 0 to +12dB @ 45 Hz. 

This port is for connecting the optional remote level control (XRB1). This allows up to 20dB of 
volume adjustment.  This is not a bass boost, it controls the level of the low pass signal.

Used to reach maximum amplifier power with a wide variety of headunits.

When set to BY the crossovers are turned off.

Controls the highpass crossover point for the speaker outputs to eliminate extreme low 
frequencies. 

This must be connected to the fused positive terminal (+12V) of the car’s battery. 

This must be connected to switched +12V, usually a trigger wire coming from the head 
unit or ignition.

This must be connected to the negative terminal of the car’s battery or bolted to a clean, 
unpainted part of the chassis of the vehicle.

Used to connect the amplifier to speakers. S250.1 and S500.1 minimum impedance of 2 ohm.