Exile Audio s250.1 Betriebsanweisung

© 2008 Exile Car Audio • www.exileaudio.com

Amplifier Manual

Connect preamp signal cables from the head unit to these terminals. 

Connect factory stereo to the corresponding terminals

Provides a full range signal for an additional amplifier. There is no signal loss if using this 
output.

Controls the crossover point for the speaker outputs.

Variable bass boost from 0 to +12dB @ 45 Hz.

2ch: Headunit has one pair of cables into front Input.
4ch: Headunit has two pairs of cables into front and rear inputs. 

This port is for connecting the optional remote level control (XRB1). This allows up to 20dB 
of volume adjustment.  This is not a bass boost, it controls the level of the entire low pass 
signal of the rear channels.

Used to reach maximum amplifier power with a wide variety of headunits. 

FLAT: Crossovers are turned off
HP: High pass crossover is on
LP: Low pass crossover is on 

This must be connected to the fused positive terminal (+12V) of the car’s battery. 

 

This must be connected to switched +12V, usually a trigger wire coming from the head 
unit or ignition.

 

This must be connected to the negative terminal of the car’s battery or bolted to a clean, 
unpainted part of the chassis of the vehicle.

Used to connect the amplifier to speakers. Use the left + and right - terminals for bridged 
mode. Minimum impedance is 4 ohm bridged or 2 ohm stereo.