Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Panasonic
  4. ag-3da1
  5. Benutzerhandbuch

Panasonic ag-3da1 Benutzerhandbuch

Download
Seite von 96
Shooting
33
Protecting SD Memory Cards
Move the write-protect switch on the SD Memory 
Card to the “LOCK” position to prevent recorded 
contents being accidentally erased from the card.
LOCK
Write-protect 
switch
Repairing SD Memory Cards
Never remove the SD Memory Card or 
disconnect the battery or DC cable’s battery 
connector while the SD Memory Card access 
lamp is flashing, as doing so may damage the 
SD Memory Card. In the event that the SD 
Memory Card has been removed while the SD 
Memory Card access lamp was flashing, or 
that the battery or DC cable’s battery connector 
has been disconnected during recording or 
the recording finalization process, a repair 
verification screen will be displayed the next time 
the power is switched on in order to allow errors 
to be repaired.
In this case, use the AVCCAM Restorer contents 
repair software to repair the errors.
 
Removing SD Memory Cards
1
  Tilt the viewfinder upwards, and open the 
SD Memory Card slot cover by sliding the 
OPEN lever to the right.
Ensure that the SD Memory Card access 
lamps are not flashing before opening the 
cover.
2
  Press the center of the SD Memory Card 
so that it pops out slightly, and pull the 
card straight outwards.
2
1
SD Memory Card 
access lamps
Do not remove the SD Memory Card 
or switch off the power in the following 
circumstances. Doing so may damage your 
SD Memory Card.
  1)  While the SD Memory Card access lamp 
is still flashing after an SD Memory Card 
has been inserted.
  )  While the SD Memory Card access lamp 
is flashing such as during recording or 
during recording finalization. 
It is recommended that you note “Right” or 
“Left” on the SD Memory Cards. If the left 
and right SD Memory Cards are inserted in 
the wrong respective slots, CHECK CARD 
LEFT/RIGHT is displayed on the viewfinder 
and LCD monitor.
•
•
•