Panasonic AG-HPX500 Betriebsanweisung
115
Properties
C
h
ap
te
r 6 M
an
ip
u
la
tin
g C
lip
lip
s w
ith T
h
ith T
h
u
m
b
n
ail
s
3
P2 Card memory capacity/Total Capacity
Displays the used memory capacity on a P2 card
and the total capacity, in minutes.
Because fractions are truncated, the figure shown
for used memory capacity on a P2 card may differ
from the figure for total capacity.
The used memory capacity of a write-protected
P2 card is displayed as 100%.
and the total capacity, in minutes.
Because fractions are truncated, the figure shown
for used memory capacity on a P2 card may differ
from the figure for total capacity.
The used memory capacity of a write-protected
P2 card is displayed as 100%.
4
Total used memory capacity for all slots
• Displays the total used memory capacity for all
4 slots.
• When REC FUNCTION (RECORDING SETUP)
is set to LOOP, this indication shows the
minimum guaranteed recording time for the loop
recording. When “USE” is selected, the value
of this indication is greater than the actual used
memory capacity.
minimum guaranteed recording time for the loop
recording. When “USE” is selected, the value
of this indication is greater than the actual used
memory capacity.
5
Warning card mark
The mark appears when the following P2 cards
are inserted.
• DIR ENTRY NG
• RUN DOWN CARD
Use the
are inserted.
• DIR ENTRY NG
• RUN DOWN CARD
Use the
2
P2 card status to check the nature of
the warning.
SD memory card Status
Display
Display
The status display enables a confirmation of the SD
memory card formatted condition, available memory
capacity etc.
Select PROPERTY → DEVICES → SD CARD.
memory card formatted condition, available memory
capacity etc.
Select PROPERTY → DEVICES → SD CARD.
■
Screen showing SD memory card data
•
SD STANDARD: This indicates whether the SD
memory card was formatted
in compliance with the SD
standard (SUPPORTED/NOT
SUPPORTED).
in compliance with the SD
standard (SUPPORTED/NOT
SUPPORTED).
<Note>
For an SDHC card, the space of 32 KB remains used
even after being formatted.
For an SDHC card, the space of 32 KB remains used
even after being formatted.
•
USED: Space used
•
BLANK: Space available
•
TOTAL: Total space
•
NUMBER OF CLIPS: Number of clips
•
PROTECT: This indicates that the SD memory card
is write protected.
Confirmation of Metadata
Upload
Upload
• The contents of the metadata upload file that is read
from the SD memory card can be checked.
• Select META DATA → PROPERTY. The following
screen appears:
For more information on each item, see [Setting of Clip
Meta Data] (page 109).
• The META NAME is the meta data name written in
Meta Data] (page 109).
• The META NAME is the meta data name written in
the meta data upload file, and is not recorded in the
clip.
clip.