Panasonic aj-sdx900 Benutzerhandbuch

77

REC TALLY

RED
GREEN
CHAR

For selecting the method used to inform the
user that the unit is recording when a system
using an extender or other device is
configured and BOTH is selected as the 26-
PIN CONTROL menu item setting while the
system is used in the remote control mode.
RED:

The red tally lamp lights.

GREEN: The green tally lamp lights.
CHAR:

The letters “REC” appear on the
viewfinder.

CAMERA MODE

60i
30P
24P
24PA

For selecting the camera’s operation mode.
60i:

The camera operates in the 60i mode.

The camera operates in the 30P
mode.

The camera operates in the 24P
mode. (2 : 3)

24PA: The camera operates in the 24PA

mode. (2 : 3 : 3 :2)

PB MODE

MANUAL
AUTO

For selecting the playback mode.
MANUAL: The playback mode accords with the

25M or 50M setting of the REC
MODE item.
Operation proceeds with 16:9 or 4:3
read from the tape.

AUTO: In this mode, the recording mode is

automatically detected and playback
is performed in the same mode.

REC MODE

16:9/50M
4:3/50M
16:9/25M
4:3/25M

For selecting the mode in which to record the
signals on the VTR.
16:9/50M: <16:9> signals are recorded at 50

Mbps.

4:3/50M: <4:3> signals are recorded at 50

Mbps.

16:9/25M: <16:9> signals are recorded at 25

Mbps.

4:3/25M: <4:3> signals are recorded at 25

Mbps.

V.RES (24/30P)

INTRLCE
PROG.

For selecting the vertical resolution when 25P
is selected.
INTRLCE: Line mixing is used to produce

more natural images.

Line mixing is not performed.
When editing after shooting, true
progressive images are obtained.

<Note>
When PROG. has been selected, progressive
segment frame images are produced,
enabling true progressive editing.  However,
since unnatural images will be obtained if
vertical detail (V.DTL) is added, it is
recommended that V.DTL be set to zero for
use.  (Even when zero has been set for
V.DTL, a sufficient vertical response is
assured for the images after progressive
editing.)

The underlining in the variable range column indicates the setting in the preset mode.

SET UP 50

O%
7.5%A

For selecting the setup.  (For 50M recording).
0%:

The setup is set to 0% for both the
camera output signals and the signals
on the tape.

7.5%A: The setup is set to 7.5% for the

camera output signals and 0% for the
signals on the tape.

SET UP 25

O%
7.5%
7.5%A

For selecting the setup.  (For 25M recording).
0%:

The setup is set to 0% for both the
camera output signals and the signals
on the tape.

The setup is set to 7.5% for both the
camera output signals and the signals
on the tape.

7.5%A: The setup is set to 7.5% for the

camera output signals and 0% for the
signals on the tape.

REC SIGNAL

CAM
VIDEO

For selecting the video input signals.
CAM:

The signals from the camera are
recorded.

VIDEO: The signals from the GENLOCK IN

connector are recorded.

<Note>
CAM is always set when the power is next
turned on after it being turned off.