Panasonic PV-GS36 Bedienungsanleitung

Seite von 76
Others
61
„
 LCD Monitor/Viewfinder/Lens Hood
 LCD Monitor
•  In a place with drastic temperature changes, 
condensation may form on the LCD Monitor. Wipe 
it with a soft dry cloth.
•  If your Camcorder is extremely cold when you turn 
its power on, the image on the LCD Monitor is 
slightly darker than usual at first. However, as the 
internal temperature increases, it goes back to the 
normal brightness.
 Viewfinder
•  Do not direct the Viewfinder or Lens to the sun. 
Internal components may be seriously damaged.
•  When the Camcorder is used with a large capacity 
Battery attached to it, it is not practical to look in the 
Viewfinder from behind the Battery.
Lens Hood
•  When you wish to attach the Tele Conversion 
Lens (not supplied), Wide Conversion Lens (not 
supplied), MC Protector (not supplied), or ND Filter 
(not supplied), rotate these in a clockwise direction.
•  If you push the [W/T] Lever toward [W] during 
recording with the filter and conversion lens 
attached to the Camcorder, 4 corners of the 
image may become dark (vignetting). For details, 
please refer to the operating instructions of your 
accessories.
Before Requesting Service 
(Problems and Solutions)
Power/Body
The Camcorder power cannot be turned on.
•  Is the battery fully charged? Use a fully charged 
battery.
•  The battery protection circuit may have operated. 
Attach the battery to the AC adaptor for 5 to 
10 seconds. If the Camcorder still cannot be used, 
the battery is faulty.
•  Is the LCD Monitor or the Viewfinder open?
The Camcorder power is turned off 
automatically.
•  If you set [   POWER SAVE] to [5 MINUTES] 
and do not operate the Camcorder for about 
5 continuous minutes, the power is automatically 
turned off for tape protection and power 
conservation. To resume recording, turn the [OFF/
ON] switch to [OFF]. Then turn it to [ON] again. 
(p. 23) Also, if you set [   POWER SAVE] to 
[OFF], the power does not automatically turn off.
The Camcorder power does not stay on long 
enough.
•  Is the battery low? If the remaining battery power 
indication is flashing or the message [LOW 
BATTERY] is displayed, the battery has run 
down. Charge the battery or attach a fully charged 
battery. (p. 12)
•  Has condensation occurred? When you carry the 
Camcorder from a cold place into a warm place, 
condensation may occur inside it. If so, the power 
is turned off automatically, disabling all operations 
except for taking cassettes out. Wait until the 
condensation indication disappears. (p. 59)
Battery runs down quickly.
•  Is the battery fully charged? Charge it with the AC 
adaptor. (p. 11)
•  Are you using the battery in an extremely cold 
place? The battery is affected by ambient 
temperature. In cold places, the operating time of 
the battery becomes shorter.
•  Has the battery worn out? The battery has a 
limited life. If the operating time is still too short 
even after the battery is fully charged, depending 
on the usage, the battery has worn out and can no 
longer be used.
Extremely high precision technology is employed 
to produce the LCD Monitor screen featuring a 
total of approximately 105,000 pixels. The result 
is more than 99.99 % effective pixels with a 
mere 0.01 % of the pixels inactive or always lit. 
However, this is not a malfunction and does not 
affect the recorded picture.
Extremely high precision technology is employed 
to produce the Viewfinder screen featuring a 
total of approximately 113,000 pixels. The result 
is more than 99.99 % effective pixels with a 
mere 0.01 % of the pixels inactive or always lit. 
However, this is not a malfunction and does not 
affect the recorded picture.